Válvulas de escape Honda NSR250 MC28

TYGA flywheel/RC valve remover, Honda NSR125/150/250/300

52,57

This new, TYGA designed 2 in 1 combination tool is a flywheel puller and RC valve removing tool all in one handy package.

Saves space in your toolbox, and less clutter on the work bench.

How to use:

Familiarise yourself with the parts (see picture).

The tool is delivered ready for use as a flywheel puller. Just screw part “D” into the crank, then wind the (left hand) threaded main body (part “A”) into the flywheel centre and pop the flywheel off by rotating part “B” clockwise. Part “C” is not used.

For removing the RC valve shaft remove part “B” completely and refit from the opposite end, screwing all the way home. Then slide in the part “C”. Position the tool over the valve shaft and wind part “C” onto the RC valve shaft (left hand thread). When fully home just rotate part “B” anti-clockwise to pull out the shaft. The RC valve shaft seal and E-clip will probably be damaged in the process, and should be replaced. Part “D” is not used.

22mm and 19mm spanners (not supplied) are required for correct operation.

*Note* This tool can be used on the NSR150 to remove the RC valve shaft, but will not fit the flywheel. Please use TYTO-0007 for this job.

Mostrando el único resultado

Contacta con nosotros

No siempre estamos disponibles. Sin embargo, nos puede enviar un email y nos pondremos en contacto contigo lo antes posible.

¿No es legible? Cambia el texto. captcha txt
0

Este sitio web utiliza cookies para que usted tenga la mejor experiencia de usuario. Si continúa navegando está dando su consentimiento para la aceptación de las mencionadas cookies y la aceptación de nuestra política de cookies, pinche el enlace para mayor información.

ACEPTAR
Aviso de cookies