Exhaust set stainless steel, Aprilia RS125

430,26

APRILIA RS125

Cámara de escape en acero inoxidable.

La cámara de acero inoxidable Aprilia RS-125 de TYGA Performance, cuando se usa con un silenciador TYGA, ofrece un enorme ahorro de peso y un aumento de potencia sobre el sistema original. Los conos hechos a mano están soldados con TIG para mostrar los anillos de soldadura al máximo efecto; este sistema es imprescindible para el propietario de Aprilia RS-125 y se adapta a todas las versiones hasta 2011 inclusive. 

Este producto es el conjunto de cámara solamente y para completar el sistema también deberá solicitar un silenciador. 

Se incluye : 

A.) 1 juego de cámara X (EXCS-0013 o EXCS-0019). Cuando ordene este producto, recibirá incluido en el juego de cámara:

1 cámara 
1 boquilla
2 muelles
1 abrazadera 

1  instrucciones de montaje

No se incluye en este producto es el silenciador. Por favor, pídalo por separado en aluminio, carbono o kevlar

Como es el caso con cualquier actualización de potencia, es importante que realice ajustes a la carburación según sea necesario.

Descripción

.Set, Exhaust Chamber, Stainless Steel, Aprilia RS-125

Cone welded stainless steel exhaust, for your RS125 performance and look!

The TYGA Performance Aprilia RS-125 Stainless Steel chamber, when used with a TYGA silencer, offers huge saving in weight and increase in power over the stock system. The handcrafted cones are TIG welded together to show the weld rings to maximum affect; this system is a must for the Aprilia RS-125 owner and fits all versions up to and including 2011

This products is the chamber set only and to complete the full replacement exhaust system for your Aprilia RS125 you will need to order a silencer too.

Included in this product:

A.)1 X chamber set (EXCS-0013 or EXCS-0019). When you order this product, you will receive included in the chamber set:

1 X chamber
1 X manifolds with flange and ‘o’ring
2 X manifold to chamber springs
1 X clamp and mounting hardware

Not included in this product is the silencer. Please order separately:

B.)1 X silencer (EXSL-0003, EXSL-0004 OR EXSL-0005) of your choice. Each silencer is provided with mounting hardware and will have a badge attached on the correct side for this system when ordered at the same time.

As is the case with any power upgrade, it is important that you make adjustments to the carburation as necessary. The dyno graph shown had the jetting adjusted one size leaner on the main jet and one clip richer on the needle for optimum performance. However, you will need to adjust your bike’s settings according to your ambient condition. If in doubt, start with a rich setting across the range, and lean off as required. Failure to correctly set up the carburation could result in engine damage.